Edelbrock 2958 Engine Intake Manifold
by Edelbrock
SKU ds_BDVJ_2958
Proudly Canadian
Albertan Owned
Supporting Canadian truckers since 2018
Secure Payments
Financing Available
SSL encrypted checkout with financing options
Trusted Brands
Top-Quality Suppliers
Authorized dealer for Fox, Bilstein, BFGoodrich & 50+ brands
Sold out
Original price
$312.44
-
Original price
$312.44
Original price
$312.44
$312.44
-
$312.44
Current price
$312.44
Availability:
Out of stock
Description
The Edelbrock Victor 18 degree #2958 Spider intake manifold features intake runners with a large cross-section area of 3.2 square-inches for max high-end horsepower in engines operating from 5000 to 8500 rpm with GM or Edelbrock 18 degree heads. Features 1/2" female pipe bosses over rear water outlets to allow for customization of cooling system and dual distributor clamp locations for ease of timing adjustment. Relief for center water outlets included. The Spider is part of a two-piece design and can be used with Edelbrock base plate #2992. The Edelbrock Victor 18 degree #2958 is a single-plane, high-rise intake designed for maximum race-winning power at higher engine speeds
Specifications
| Description_ASM | Chevrolet:Small-Block Gen I Race |
| Description_DEF | Engine Intake Manifold |
| Description_LAB | Spider Intake for #2950 SBC Manifold |
| Description_MKT | The Edelbrock Victor 18 degree #2958 Spider intake manifold features intake runners with a large cross-section area of 3.2 square-inches for max high-end horsepower in engines operating from 5000 to 8500 rpm with GM or Edelbrock 18 degree heads. Features 1/2" female pipe bosses over rear water outlets to allow for customization of cooling system and dual distributor clamp locations for ease of timing adjustment. Relief for center water outlets included. The Spider is part of a two-piece design and can be used with Edelbrock base plate #2992. The Edelbrock Victor 18 degree #2958 is a single-plane, high-rise intake designed for maximum race-winning power at higher engine speeds |
| Description_TRA | Hardened washers Must be used with intake bolts to ensure proper torque and prevent galling of the aluminum. |
| Description_TRA | Recommended Intake Gasket: Fel-Pro #1282 |
| Description_TRA | Use RTV sealant to properly seal end seals, such as Edelbrock High Temp Silicone sealant #1076, DO NOT USE END SEALS GASKETS. |
| height | 7.5 |
| length | 23.625 |
| RGL | WARNING: This product can expose you to Lead, which is known to the State of California to cause cancer or birth defects or other reproductive harm. For more information, visit www.P65warnings.ca.gov. |
| weight | 12.15 |
| width | 14.75 |
